Date: 23 Sep 2006 19:38:26
From:
Subject: need help with terminology
|
1. I am back to the game, haven't recaptured form yet :) but I am
working on it. I read everything I can find, but I am not
understanding the terms that are new to me, like leverage drilling,
axis drilling, 45-60-75-90 degrees etc. When someone speaks of label
drilling is that what I am accustomed to, when I could look at my ball
and tell the static weights?
2. I once read Bill Taylor's book, has it been updated to include
today's layouts, if not, is there anything that does?
3. I seem to be getting tidbits that are fragmented and I am not sure
I am even interpreting the information correctly. My style is to go
long with a strong backend, I gather for me the pin goes over the
fingers, there is some point that should move from 3 3/8 to 5.5 and I
should use a 90degree vs a lower degree layout. I don't even know how
this applies, can I take the label and say drill it with an once on
the fingers and one on the side and get my old reactions or something
close?
tia
|
